The Raspberry Pi 4 was launched on 24th June and has been well received, to say the least. The spec is a big step up on previous models. It has 4 CPU cores like the Pi 2, a gigabit port like the Pi 3, plus USB 3, a better SoC, a separated bus architecture, faster memory and more of it.
Over the years, many “home” devices have been launched with Gigabit Ethernet, promising lightning fast network speeds, only to disappoint due to their lack of overall grunt. The Linkstation Live, the Sheevaplug and, to a lesser extent the Pi 3 are all on that category, unable to push their gigabit ports to more than about 14, 8 and 12 megabytes/sec respectively, due to the limitations of the CPU and the board. Is the Pi 4 the same, or can it operate as a serious NAS ?
Short answer: Yes. The Pi 4 is a *serious* NAS contender. Sustained write speeds of over 68 MB/s were obtained, and over 105 MB/s for reading, including saturation of the Gigabit network. Yes, the Pi 4 can push even a 1000 MB/s network to 100%.
Nextcloud is an open source software package providing remote file sharing services. It is similar to Dropbox. But with Nextcloud, you retain ownership, security and control of the shared data. This procedure describes how to build a working Nextcloud service using just 3 commands. It has been tested on Raspbian Stretch and on the Raspberry Pi 4 / Raspbian Buster (this article updated 9/8/19)
Note: If you would rather do the installation manually, step-by-step, without the help of a script, please see my previous article “Simple Nextcloud Installation on Raspberry Pi“. It explains how to do the installation in detail, and provides more background information on Nextcloud. Both procedures achieve the same overall result, however.
Note: If you are running Raspbian Buster, then Nextcloud 16 will be installed. For Stretch, it’s Nextcloud 15.
This article explains how to install Nextcloud on the Raspberry Pi. It has been tested with the latest version of Nextcloud (16.0.3 at the time of writing), but should work for future versions too. It has also been successfully tested on the latest Pi hardware, the Raspberry Pi 4, and on earlier Pi versions, and on the latest Pi OS, Raspbian 10 “Buster”.
Nextcloud is an open source software package providing remote file sharing services, similar to Dropbox. But with Nextcloud, you retain ownership, security and control of the shared data. Nextcloud works well on a Pi 2, Pi 3 and especially a Pi 4 but will run very slowly on a Pi 1.
Note: This is a manual, step-by-step procedure. If you would rather do the installation automatically, please see my recent article Automatic Nextcloud Installation on Raspberry Pi, which explains how to install Nextcloud with 3 commands. It is the quickest and easiest way to get Nextcloud running. Both procedures achieve the same overall result, however. Continue reading →